Been playing around with a 311284 single cavity HP mould that was modified in the past(not a factory HP mould). Bored out the HP pin bore to .260 dia and made a flat point pin. The bullet cast is 214 gr -w- GC, have shot a few in my NEF 30/30. Seem to be stable at 50 yds. I intend to work up a load for a new to me Rem pump rifle -w- an 18 inch 10 inch twist 308 barrel. Use will be 100 yard or less shots shots on feral pigs. Is 2000 FPS possible with this bullet in my barrel? Bullet is 1.10 inches long, .311 dia., 214 grains -w- the gas check, .260 dia. flat point. Want the tissue destruction of the flat point, but need the penetration for corner to corner shots on big pigs.