Anyone used such a tool.
Pliers like ; that indents the neck to keep lead bullets in.
I am starting to play with such an idea.
I haven’t a loading tool for this case but finger seat the healed cast bullet in my 310 cadet cases.
After a while some cases get a bit thin around the neck area and the bullets want to fall out , even if I use a bit of lube to keep them in.
I found a crimp tool of sorts I can indent my cases and keep the bullet in the case.
Good for me Whoohoo.
I’m hoping that the indent expands some with firing and make the next bullet seated into the case a firm fit.
If not it will tear a groove down the heal of the bullet and make a mess of accuracy and my barrel.
Anyone have much experience in indenting brass cases.
I will report when I get time to fire them.
Thanks.
Bruce.