Like many of you, I've done many thousands of shake n' bake PC bullets and have shot them in all kinds of handguns and rifles.
My 30 cal bullets will lead the gas port in my auto loading rifles, even with a gas check.
I'd like to make some .225 cal bullets but I want to push these faster and get much less or no leading on my BCG or ports.
I'm not sure if it would make a difference but I'd like to try using a powder gun to coat the little pills to get a thicker more even coat.
My plan is to take two aluminum 1/4" plates and drill holes the size of the gas check to stand up the boolits. After a spray I'm going to transfer them to my second identical plate so I don't get baked on coating on my plates. Then size with a GC.
Has anyone tried this and if so was there any leading in your gas system?