I got a 1906 vintage commercial Colt 1892 model, but it has a broken leaf spring on the 2nd cylinder bolt stop. Appears to be a common problem looking online, but looks like NOS parts can be found, or made from some simple spring shim stock. I hope it shows up this week at my LGS, but likely next week before I see it. Bore looks promising with only a couple of pitted spots about half way down....it is a 4 inch. barrel. My Redding dies came today and look very nice, hollow base bullet mold should be here tomorrow...so getting there. Was tempted to order the replacement spring, but decided to wait and see if there are any other parts to replace while I'm in there.
Question - I'm a little low on Bullseye and Unique powders....anybody used Titegroup? My guess is that a "similar" charge for a .38 Special target load would be in the same class?