As title says I'm looking at a mold on NOE site. To be more specific is HTC359-129-TC-CD4 5 Cavity PB.
I was wondering if a bullet that drops out of a mold at .359 could be used for both 9mm and .38spl or even .357. The idea of a mold doing two jobs is awesome. The 129 grains is very decent for plinking for both 9mm and .38 spl.
Now I have few questions:
Would be any issue to size a bullet from .359 to .356 after powder coating or HTC ? I never tried sizing that much.
Any cons for a plane base bullet other than belling the brass mouth a hair more than the beveled base.
As I said I'm really flirting with the idea of having a mold for two calibers and I was wondering if my expectations are realistic or not.
Thank you