I was doing some casting a couple of weeks ago and came across my old Lee 452 230 TC TL mold. I went ahead and cast some, then PCd them for fun. For some reason I can't find any load data for them. I intend to just use regular 225/230 load data, but I can't seem to find any OAL info on it that. I plunked a dummy round into a 1911 barrel as well as my FM45 PCC and have to seat it down to about 1.177" OAL to get it to chamber. Does anyone have any experience with this mold that would like to impart some knowledge? I'm just concerned with pressure if I seat it too deep. Am I over thinking this and if it seats it yeets? For the record, I ran across a few pounds of Ramshot Zip at what amounts to a reasonable price these days and was going to try it out on these rounds rather than the 231 I ordinarily use.