I am messing around I admit , I plan on making 1 at least
I am ( So far most of the design is just on paper ) designing a 9mm bullpup rifle
I have some of it 3D printed for testing of ideas
As making test parts from PLA is cheap
I will also admit this design is taking a while with my headaches
So far I plan on a 16 1/2" threaded barrel
26 1/2" OAL
Takes Glock mags
Hammer , sear and pistol grip from a AR15 as I have them
But I may change the the sear and hammer to AK47 parts as I have them also
I need to do a bunch of testing as to what to use
Most of the bolt mass and the main spring will be in front of the chamber and above the barrel
BUT so far the sticking point is giving the rifle a decent trigger pull
I made a mock up of the stock to try and get a decent trigger pull
Mushy and long was the best I have gotten so far
I figured I should address this BEFORE I start cutting the parts for the action
I had a thought , as I have seen them in high end rifles
A electronic rifle trigger
Are electronic triggers doable for a hobby maker ?
Or should I just work out a reasonable trigger linkage ?
Your thoughts ?
Thanks
John