I see that I can seat an over sized cast in a fired case as long as the case chambers freely. I pin gauges a fired case on a 44, and it's .430. I plan on casting a .432 boolit, and my groove is .431. The throats are a tad bit over .432.
IF I decide to load per say a .431 cast, and will a light crimp to rid the bell be enough with .001 tension not cause the boolits to back out of the case with recoil ? Or just give it a decent crimp and I'll be fine. I ask this because I'm sure a crimp effects neck tension of course, but how much ? Is a Lee factory a better way to go ?