I had run a hundred. 38 Specials the week before, thought I would run another 100 for my brother last Wednesday evening. I poured my Clays powder in, and cycled the press a few times to check the powder throw. It was nearly spot on for 2.8 grains. I started cranking out loaded rounds, about 50 rounds in, I checked the case, after the powder drop, empty! Son of a biscut! A screw had loosened on the crank mechanism that cycles the !
powder measure, allowing the little plastic square out of the groove it rides in. I changed out the nut to a locking style and found a small spring to attempt to keep the plastic square in place. Back in business. Today I cranked out about 300 this afternoon, used up some 358477, prior to me started powder coating.i need to be 'in the moment , pay close attention to every detail. I like going to break them Dow and re run them.
hc18flyer