Thank goodness I picked up a Hollywood senior a while back ..
It's been quite a while since I last processed all my 308 brass (quite a bit of once fired military) so I had to start again .
I have a small custom steel table that has a chain link pipe vise on one end , so I take that off of it's 3 bolt mount and set the senior in place to utilize the one hole in the rear .
With that , part of it hangs out off the edge but with the steel table and the thick senior build , wow! , solid as all get out.
Seeing as how I use a RCBS small base sizer , once in a while one takes a two handed effort pushing down on the handle even with lots of lube , What a beast !
My main press is a Lee classic cast four hole but that is sometimes questionable when it come to using a small base die.
Also have another Hollywood , forgot the description but it is the tall one with the three hole pivot top next to my Lee as I like to seat and crimp on it.
Feel a bit better for seating alignment using it.
Get comments from friends once it a while about them ..What are those ?....