I found a 1916 pattern small ring last month, it has been re-fit for 308. This was an arsenal job, the bbl, reciever, bolt, & bottom metal all match. The wood is in very good shape also. Very little clean up was needed. always was a fan of small rings.
My question is how to start working up a mouse fart load using a 311410 boollit
with bullseye for this. Powders I have are, red dot bullseye, green dot, others. What I have been thinking is to start with 3.5 grs of bullseye, then work up or down as needed, trying to stay sub sonic. The rear site is 200 meters at its lowest setting, so may have to adjust load to match. I also have the lee 160 tl boolit, made some dummys with both & they feed fine from the mag. I'll
be useing lc 87 brass for the cases, i have read the posts coveribg drilling the flash holes, any imput bout this will help.
I hve used bullseye & the 311410 for gallery loads in a 03a3, & 3040 krsg with good results, just not sure where to begin this time.