As I said, IF I want full length sizing I set the die deep. Normally I partial size not touching the shoulder and leaving a few thousand of unsized neck. If I need to set the neck back, I adjust the die in small steps just enough to chamber a round. This takes into account any slop that the press may have. Not that most of my presses have enough slop to make any real difference.
Finally ran into a fella that has one, told me how he deprimed on it once and never again. Because of the spent primers passing through the ram, through the press into the little cup. Residue would work its way between the ram and base also into the neat bearings on the linkage.
A jewel of a press like that should not suffer dirty work like depriming.
There are things I load that don’t require much precision but if that’s what I am after, a turret isn’t what I use. The Lee might be the best design out of all of them though because it’s not a turret mounted by a post in the center. They don’t tilt back and forth like the one in the video on the first page.
I agree. If I was into extreme accuracy, I would not use one of my turret or progressive presses. Most likely would use my co ax or my Herters super O. I haven't tested the Herters but I doubt it would flex much.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |