Hello All, I just joined your forum yesterday5/19/23 didn’t even know a site like this existed, I really need to get out more LOL. But anyway I have been casting for many many years sort of forced into it because of extreme projectile prices. Here is my question I am looking for someone or company that will build a mold to spec sort off a one off I guess but as the title states a .243/6mm copy of a 110 Hornady A Tip with the usual gas check set up and so forth, 7 twist barrel Bighorn TL3 Bolt receiver on a manners TCS Chassis, I shoot PRS and this bullet if possible will be for a 6mm Dasher cartridge to do positional work out to 4 to 600 yards nothing to fare. Even shooting seconds in 107 from creedmore sports is getting costly for just doing the positional stuff smacking steel. If any of you knowledgeable fellas or gals can point me to someone it would be greatly appreciated, I mold with the usual Lyman/Lee molds and handles along with a seen better days Lee production pot that’s about the run down of things, Thanks to all and looking forward to the answers if any…