Is there a mold out there anywhere? Been doing some searching but can't find anything current.
Is there a mold out there anywhere? Been doing some searching but can't find anything current.
https://noebulletmolds.com/site/prod...325-133-fn-p1/
Not sure about feeding with the flat nose, RCBS discontinued their mold.
More "This is what happened when I,,,,," and less "What would happen if I,,,,"
Last of the original Group Buy Honcho's.
"Dueling should have never been made illegal in this country. It settled lots of issues between folks."- Char-Gar
Rides et Ratio
Hmmm... 133gr might be a tad big but there's probably room enough in the case. I have multiple 8mm sizing dies so I'm sure I can get to my desired width.
Curious if anyone has experience cycling this bullet. Grafs has an abundance of 83gr J-words so I'll have to ponder on it.
Try Accurate bullet molds 32-096S, a .323 diameter RF 96 grain bullet that more closely approximates the 102 grain originals.
_________________________________________________It's not that I can't spell: it is that I can't type.
More "This is what happened when I,,,,," and less "What would happen if I,,,,"
Last of the original Group Buy Honcho's.
"Dueling should have never been made illegal in this country. It settled lots of issues between folks."- Char-Gar
Rides et Ratio
Try LBT, Years ago Vernal made me a great 4 cavity mold for my Nambu that shoots far better than the RCBS mold(dumped it) even better when they are spray gun powder coated, accurate, smooth as glass, pretty to look at, and clean up is a breeze as, no leading!
Sorry, just found out from another post that his factory burned down.
Last edited by rrob692326; 03-27-2023 at 01:01 AM.
If you can locate one, Lyman made a 32359 I think it was. Had one at one time. Someone on the site here traded it from me.
Federal at one time made arun of 8mm Nambu ammunition/cases. Headstamped FC 8mm Nambu. Had a couple but haven't seen any in years./beagle
diplomacy is being able to say, "nice doggie" until you find a big rock.....
Buffalo Arms carries cast bullets for the Nambu.
Rights, and Privileges, are not synonymous. We have the Right to Bear Arms. As soon as the Government mandates firearm registration, and permiting, then that Right becomes a Privilege, and may be taken away at our Master's discretion.
Buffalo Arms has a mold https://www.buffaloarms.com/323-105-...jim323105.html
Correction.. had
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |