Looking for some guidance, I have traditionally used speer shot capsules in 38 and 357 with 3 pieces of number 1 shot in them for fun rounds, however with the shotshells being hard to come by I have been venturing out into new ideas. With that I am thinking about doing is stacking short wadcutters in 357 magnum and in my 357 max. Anyone have any kind of load data suggestions for the 357max with 3 - 75gn wadcutters stacked up for a total weight of around 225gn? I can find plenty of gas checked and jacketed data but obviously this will be too fast for the naked based wadcutters. Am I even thinking properly????? Also a starting load data for a pair of them stacked in 357 mag would be appreciated as well. Data is out there for single bullets in that weight but I'm just looking for personal experience. Any tips and tricks welcomed. Planning to shoot the 357 max out of a 16" contender. 357 magnums are all revolvers 1 of which is a ported barrel. The speer capsules state to not use in a ported barrel. Any opinions on shooting these stacked wadcutters from a ported barrel?