Looking for recommendation for a 8x57 mold, it will be used for plinking in model 98's in 8x57 and 8mm-06?
Thanks
Looking for recommendation for a 8x57 mold, it will be used for plinking in model 98's in 8x57 and 8mm-06?
Thanks
I use the Lee mold, it shoots very well.
I use the RCBS 08-170-FN gas checked. My 98 really likes this one at about 1800-1850fps.
Lyman 323470
NRA Benefactor Member NRA Golden Eagle
My bullet of choice for the 8x57 is the Saeco #081. My second choice would have been the RCBS 08-170-FN, but that mold was discontinued a long time ago.
I mostly used the Lee 175 gr for plinking.
It is a good Boolit and heavy enough to hunt smaller deer with.
But for Long Range I use a heavier slug like a 198 gr , I think by NOE
I also like the RCBS 08170 FN.
dabrown,
8x57's can sometimes be a challenge depending upon the amount of erosion right in front of the chamber.
I'd try the Lee mold first and if it worked for the 8-06 but not in a 8x57 then maybe a heavier mold mite work for the 8x57.
Hard to forecast.
I would like to thank everyone for their time and input, I think I will go with the LEE for now and look for the RCBS (they always turn up eventually).
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |