All, Looking for a critique on my first stab at this PC stuff. Pictures below and appreciate any feedback for improvements. Bullet's were cast using MP 359-640 with 50/50/smidge of pewter and coated as a my first PC experiment so some of them are ugly. Had zero issues with the .359's other than needing a little more coverage. Pictures are coated (Smokes' Signal Blue), cooked (oven calibrated to 400 degrees for 20 minutes), smash test and then after sizing (bullets on towel). Also tried the MP 402 -190 but couldn't size the bullets with the NOE .401 push thru sizer. Measured them and they were .405-.406". I could size them using the .401 die in the LAM. So is this a case of having to size before PCing and then final size later?