I hope i can describe the issue well enough to get my point across....
My H&G Moulds seem to have the handle screws (the fasteners that hold the handles to the mould blocks) that when mounted, are not flush with the mould.
If it were a two cavity moulds it wouldn't be a problem.
However, since i cast in multiple manic sessions with 4-6-8 or 10 cavity H&G's, it DOES pose a problem. When you are casting 1000-1500 a session, one little bump in the production does hurt.
Here is why: I use a new RBCS Pro Melt with the mould guide and the handle screws stick up forcing me to lift the mould over the mould guide because the protruding screws prevent a smooth motion as I am pouring into the mould front to back (or vice versa).
If these screws were flush to the mould, the movement would be nice and smooth all the way down the mould - even the 8 & 10 cavity moulds.
I don't know what to look for for replacements or where I might even get them.
Can anyone give me the thread pitch and the proper nomenclature for these kinds of screws? I would even be happy with Allen head screws as long as they were flush with the mould.
Your advice is most welcomed