Hello Folks,
I'm considering this mold for my 9mm pistols. I'm hoping to be able to PC and size to .357-358". But in order for this to work in my pistols with a shorter leade, I would have to crimp the bullet at the front edge of the bearing surface.
I read on some posts that this is a short bullet. Will this lead to a very short COAL?
I tried using a dummy round using a .358" 125 gr flat point cast bullet (have a few samples; magma engineering I think). In order to chamber in my Kimber and CZ my coal has to be a very short .900"!
Wondering I will end up with the same problem with this #377 Saeco mold.
Thanks in advance!