About a month ago I purchased a Stevens Favorite in .32 long rimfire. It's in decent shape and the price was right. I tried finding ammo for it but as I found out this stuff is hard to find and when I did its expensive. So, I tried to find brass that would except .22 blanks. Again, expensive. I then decided to make some brass that would except .22 blanks. After trying to reform .223 rem, 9mm, .380 brass I settled on .22 hornet brass. I shortened the hornet case and center drilled a hole large enough for .22 blank. I also had to turn a new firing pin and reposion it in the block just slightly so it would strike the edge of the .22 blanks new position. I didn't reposition enough as to make it a centerline but just enough to contact the rim of the .22 blanks new position. It works. Ill load up a few for this weekend. Maybe 10 or 15 rounds. Really looking forward to shooting this.