(32 S&W Long) Well I figured out all the internal timing ugly was a really sloppy cylinder pin and a way over cut hand. I do not believe this piece has had a box through it and no sign of disassemble. Made new pin and unbelievably found a brand new untouched hand. The bad?- cylinder pinned two at .3155" and three at .316", the new Lee mold inbound states .314" and probably going to be the one at first. What would be the best set of dies in your opinion to hunt down and lean into for hopefully minimal aggravation in seating a .314" or if needed another expander required. I have read through some and will be getting new brass for start. I see a lot online is out of stock but did not want to jump in bad from the get go. Thank you for your time!