I reload .25-35 for a friend who has not yet been able to set up a reloading area. Projectiles being non-available, I told him I'd cast boolits for him if he would provide the mould and sizing die for my Star sizer/lubricator.
It seems that moulds, also, are scarce. I found two at NOE, although neither is in stock. (I sent a query about when either might be available.) They're the same except one uses a gas check and the other is a plain base.
https://noebulletmolds.com/site/prod...60-118-rn-aj2/
260-118-RN-AJ2 2 Cavity GC
260-118-RN-AJ2 2 Cavity PB
Are there any recommendations for either version?
And if GC has a clear advantage, would the gas check be seated properly in the nose-down die for my Star? (I would ask lathesmith to make the die; he did a fine job on the .461" die he made for my .45-70 boolits.)
Thank you,
Richard