I finally found an sml 57 Lyman peep I've had in the back of a drawer (hiding from me the sneaky little bugger)
I have a 54 cal renegade this little dude will be going on but....I know I'll need to mark drill and tap the rear tang. Also need to replace or install the upper tang screw.
Question I have is, does anyone know what size that top screw is or should be (I assume it would need to be an eighth longer to account for the thickness of the sight.) Also want to match the taper on the sight well so it gets good surface contact with the screw ( ie so the taper isn't too shallow or steep and giving me contact just on the upper or lower part of the screw hole)
Anyone have suggestions on which screws work well on this?
Before I go into the project anyone have tips I should take into account?
Seems I've seen somewhere I may need to notch the stock some too to make way for the sight on the left side too. I'll test fit and see when I'm back at the gunsafe
Sent from my moto g(7) power using Tapatalk