I was ready to buy an Accurate mold for my Marlin 45-70 that has an oversize bore, and had decided on a design that has one wide lube groove:
https://www.accuratemolds.com/bullet...bullet=46-325V
Then I wondered if I was incorrectly applying a Keith handgun cast boolit style to a rifle.
The question, then, is: Should the cast rifle boolit have more than one lube groove, perhaps like this one:
https://www.accuratemolds.com/bullet...bullet=46-345B
BTW, he will cut the mold so that it throws a .462" boolit.
Thank you,
Richard