Hello all, I have a savage 260rem barrel that really likes to stick brass. I have sent it back to ER shaw and they claim everything checks out in the chamber. I was wondering if anyone on here had a 260 reamer and if it would be possible to turn a few thousandths off the bore end of the barrel and recut the chamber? Is that even a possibility? I have tried everything, neck sizing, bushings, turning necks, measured thr cases after firing, tried factory ammo, some really low powered reloads, something somewhere in the chamber is sticking brass pretty good. I assume it was cut with a worn reamer and something somewhere is undersized but I can't find it. Are my thoughts correct on cutting a bit off the threads, recutting the chamber and setting headspace again?