I have a few hundred pounds of boat lead ballast that I will eventually cast. About 50 pounds of it have been reduced to Lyman mold ingots. I have no idea of the hardness. Does that matter at all?
Stupid question of the week- can I just mold it to 9mm bullets for my CZ and fire it? Not paying any attention to hardness? I do not care about accuracy I just want it to go down range without causing a problem. My eyes glaze over when I read about tin and antimony mixes.
Right now I have everything to do some molding except a two bullet Lyman mold.
At my stage I do not want to become an expert caster, just mold some safe bullets that can be loaded and fired .........SAFELY.