I picked up a second Lyman 358156 mold NIB at a gun show a couple years ago and was thinking about plain basing it, or more precisely having it done for me, as I am leery of messing it up.
Who would do this work?
Thanks.
I picked up a second Lyman 358156 mold NIB at a gun show a couple years ago and was thinking about plain basing it, or more precisely having it done for me, as I am leery of messing it up.
Who would do this work?
Thanks.
Sure it will work but Lyman and others make molds for this without a gas check. If I didn't have one I would swap with you. To me the 358156 is more accurate at higher speeds. If a good 4 cavity we can talk.
Which way are you thinking of going, bore out gas check groove or mill off the top of the mold?
Tim
Words are weapons sharper than knives - INXS
The pen is mightier than the sword - Edward Bulwer-Lytton
The tongue is mightier than the blade - Euripides
Removing the groove.
As said, I have another but bought this one new in the box for $15. Double cavity.
Erik, at Hollowpoint Mold Service will do it for you and get it back to you pretty quickly.
Here's the link: http://www.hollowpointmold.com/
Hope this helps.
Fred
After a shooting spree, they always want to take the guns away from the people who didn't do it. - William S. Burroughs.
I have the exact same dilemma. If you mill the top you would lose the sprue plate screw seating depth as well as lessen the weight of the boolit considerably, would you not. Anyone ever done the gas check ring removal at home?
Last edited by ReloaderFred; 05-10-2021 at 11:12 AM. Reason: Edited to conform to the rules
Always do sober what you said you'd do drunk, that will teach you to keep your mouth shut!"
- Earnest Hemmingway
" I'd rather be lucky than good, GET SOME!" Mr. Revolver" - Jerry Miculek
There have been a couple of offers to buy and trade in this thread, which is a violation of the rules (even in jest). Please read the T.O.S. at the top of every page if in doubt as to what is allowed.
Hope this helps.
Reloader Fred
After a shooting spree, they always want to take the guns away from the people who didn't do it. - William S. Burroughs.
The last mold i got from Accurate molds is the same bullet I got a 5 holer 2 are gas checked 3 are plain base.Just another way to go.
I have two of the plain base 358156 molds from Tom @ Accurate Molds . They are 4 cavity molds so I can cast a lot in a short time . I have cast a boat load of cast bullets over the years . It is my primary bullet for my 38 special / 357 magnum loads as they are very accurate shooting . Regards Paul
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |