Have an old Harbor Freight band saw the kind that has 4 legs. Pretty sure it may be the switch or the capacitor. Switch is what appears to be a long toggle handled double throw double pole. So I'm guessing it shuts off both the hot and neutral wires. Either on or off. Has a longer than normal handle or toggle. When the saw finishes the cut a section on the blade part hits the longer toggle and shuts it off. I have a 10a 125 volt single pole double throw toggle switch with the longer toggle handle. Which is what the motor is rated for. Can I use this instead of a DPDT switch and just leave the neutral wire intact. Or do I need The DPDT and have it open both the hot and neutral?. Thanks in advance for your help. Frank