I have the Buffalo Arms Jim 396415E mold but think it may be a bit long for my 40 cal with 16 twist. It is 1.42" long and a Money type nose.
BA has no shorter .396 PP molds available so I was wondering if it is feasible to stick the mold in the 4 jaw and cut a few thou off the base end.
Would that upset the dynamics more than being too long?
Any suggestions for a .396 diameter PP mold Money type nose.?
The Jim .396 385 is only 1.280 long but a round bluntish nose. All are out of stock anyway.
.396 is perfect with the roll of paper I have.
Keith