Just fabricated a portable metal framed casting and sizing table. None of the items in the picture have been mounted yet, the top is 3/4" PT , stained and coated with polyurethane which will be fully dry tomorrow.
My idea is to mount the Star lube sizer where it is positioned in the picture (with the heater base I just made for it). Heater will be wire from the bottom. Would like to put a hole in the plywood so as the bullets are sized they drop into a pan below the deck? You see any concerns with this?
Feels good to me, with left hand place bullet face down on sizer and with right hand pull lever.
I can adjust the height of the drop drop by placing boards under the catch pan.
The table can then be spun around when casting with the Lyman Mag 25 pot. This is the last phase of my introduction to bullet casting.