So I figure y'all are getting a little irritated with all the questions but I got another lol. Was messing with my HM2 again , figured I had reassambled it correctly and all but can't seem to get a decent bullet out of it. Alot of them had these base sprews. Was it just me cutting them to early or could I have possibly re assabled the mold in correctly?
Further info being lead was around 800 mold was pre heated and I lived the bottom of the sprew paled with a light coat if 2 cycle oil like y'all suggested. Also I'm not sure is this gape is too much but I put the washer in the bottom of the sprew plate like I remember it originally.
Also my camera just did a really good job taking the picture and honestly it makes the gap look much bigger than it is. More than happy to post more pictures if it helps