Has anyone tried this? Looks like it might work. Could require inside neck reaming.
Has anyone tried this? Looks like it might work. Could require inside neck reaming.
Not sure, cause I figure you could trade 2:1 or 3:1 for 10mm
Should be doable, they were both based off the .30 Remington. But why? The 10mmis still available from Starline.
Robert
I have done a lot of .338 Spectre (10mm mag necked down) from 6.8 spc and it is a pain. Definitely would have to inside ream and also anneal the brass. Like the others have said it is not worth it unless it is your last option.
Sounds like a lot of work to me. 10 mm brass isn't all that hard to find see ads in swapin and selling on a fairly regular basis.
Definitely trade for 10 mm, plenty of 10 out there, 6.8, not so much.
Common sense Gun Safety . . .
Is taught at the Range!
Sometimes people just like to do things to learn how to do it. Years ago my brother bought a book on reforming brass. We spent a cold winter week making ammo for things we didn't even own to see if we could.
Unless it is something extremely rare or obscure, or something that is relatively obscure which can be performed easily from something as common as dirt, case forming seems a stupid waste of time to me. When I got a .222, I figured forming cases from .223, which I can go to any public range and leave with all I can carry away for free. After doing it a few times, I concluded .222 brass is nowhere near rare enough to justify that PITA process.
To make fairly common pistol brass from somewhat obscure rifle brass just seems to define dumb waste of time, energy and brass to me.
Don’t ruin good 6.8 brass. Especially if it’s Large primers. That stuff is hard to find I buy all I can. Most use small primers.
Sent from my iPhone using Tapatalk
Ed
CW3 USA (Ret)
VFW Life
American Legion
DAV Life
NRA Benefactor
TX State Rifle Assn Life
SAF Life
NY State Rifle and Pistol Assn Senior Member because I don't have to fight that fight in TX
JPFO Member
GOA Member
ForumCasting & ReloadingCase Forming / Re-forming
Saw this at the top and figure the OP put the post in the right place. Following with interest for only the reason that you can. I love to read threads that propose stuff like this.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |