Hello,
I decided to play with a few of my first Bullets I casted a couple weeks ago. I powder coated a few and tried to size them.
They are casting at .2795-.280
After PC .282
A lee .278 sizer is sizing them to .276 and they come out bent. I sized an uncoated bullet and it did the same thing.
Any ideas? Using range scrap. I’m not sure why the sizer is going so far undersized either.
Top 2 are unsized. Bottom have been sized.
Pc came out good except where it touched the rack I used to stand them up.
Sent from my iPhone using Tapatalk