Since loading 32 ACP on my Dillon XL650 I've experienced 2 problems that have never occurred before in years of using this press.
1) The cases do not feed consistently. Occasionally the cases do not stack vertically above the casefeed bushing preventing it from entering the bushing. Tapping the press by the casefeed tube knocks the offending case into alignment.
2) The press binds somewhere at the top of the stroke just as the handle is lowered and again a little lower in the down stroke. The binding is so severe that it knocks some powder out of an open case. I aligned the platform with Dillon's alignment tool, the one that fits into the powder funnel. The binding went away for a while but returned even though the alignment was OK.
I've had numerous email responses from Dillon but haven't been provided with any solutions yet. I've used this press for almost 5 years of light use loading 45 ACP, 38 Special and 9mm without issues until recently loading 32 ACP and 32 S&WL. This is when the problems surfaced. Any ideas on what might be causing this, esp. the binding?