Will I need to size the bullets to .356 or can they be used as cast if they come out at .358/.359? I just picked up my new 9mm and want to get some bullets loaded to try it out. New caliber for me but I've been reloading for 30+ years. I will be ordering a proper mold, but I have a couple 38 Special molds on hand and would like to get going. I've got a LEE 358 105gr SWC and an Ideal 358250 which is a 155gr RN. I'll start with the lee but the 155 might be a fun subsonic load. I'd appreciate suggestions on what a good general purpose bullet would be, ie RN, truncated cone, SWC, and weight? I'm leaning towards a 124/125 truncated cone or RN. Pistol is a Canik TP9SFx. I will likely be powder coating them. I still need to get dies, sizers, and plate for the Hornady L&L and will post a WTT/WTB for that stuff before I go to a supplier.