Any one know the dark coating the mold makers put on iron molds?
Thanks Aaron
Any one know the dark coating the mold makers put on iron molds?
Thanks Aaron
I'm not sure but I think they are just blued.
Might be? I had to remove a little rust and used Evaporust and the rust went Poof. but so did the finish!
Aaron
They could also be black oxide nitride finished.......a process that puts a nice black finish on steel......using heat, a vacuum furnace and disassociated ammonia gas ( to get the N2 out of it). Many inexpensive drill makers use that for the finish of their twist drills. Something you would not want to attempt at home.
The aerospace industry here in Phoenix uses it for special parts.
Just using the mold will color it. Heat and oxygen.
Mal
Mal Paso means Bad Pass, just so you know.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |