I just acquired a couple thousand 225 gr boolits pretty cheap that I will be powder coating soon. In looking at all the manuals I have, there is load data for 200 grain and 230 grain cast boolits, but I couldn't find anything for 225 grain. Anyone have an idea of what I should start with when going between the two weights? I have reloaded a lot for many years but I typically use printed data for all my reloading and haven't experimented with anything else. Note: I have seen that the data for the lighter of the two weights uses a higher grain weight of powder than the heavier one, so would I be safe in assuming I could just start in between somewhere? I will primarily use these for plinking and practice in my Colt 1911.