I test drove my NEI 311-154 4 cavity today and turned out some really good looking boolits, fast! I found a .7 grain difference in weight and .002" difference in diameter and was wondering if this was normal?
I found it very difficult, however, to cut the sprues. It's almost as if the handle on the sprue plate is too short and I had to resort to banging it with a mallet, also my thumb, ouch ! I reversed the mold on the handles (Lyman) but, had to drill a couple more holds so they would fit. Now the sprue plate is facing foward so maybe it will help. How do ya'll overcome this problem?-JDL