So noticed that my LEE 45 cal hollow base minie boolits weighing in at 300ish grains and measure in a generous .454 inch.
Now my Ruger 45 Colt takes .452 diameter so I ran 20 or so through my Lyman .452 sizer filled with SPG lube and loaded them in a variety of 45 Colt cases ... over 5.5 grains of Bullseye powder ... and sparked with Rem 2 1/2 primers.
Got to wondering now before taking them out shooting ... how the hollow base is going to act with the cylinder jump in my revolver.
I was shooting a very similar load in my Japchester 92 when the barrel bulged rite under the rear dovetail with no apparent pressure signs ... so beings it were used to me ... figured that it had had some abuse that I wasnt aware of in its past ... but ... these same boolits were being used when that happened ... sooo ... thought I would bring it up here and find out if others have loaded these and their experiences with them before shooting them in my Ruger revolver.
Thanks for the reply's and suggestions.