rfd,
I took the delrin oring ends off the baco wipes and put them on the gophers before I found neoprene washers and nylon nuts and other that adding a little extra length they worked fine.
rfd,
I took the delrin oring ends off the baco wipes and put them on the gophers before I found neoprene washers and nylon nuts and other that adding a little extra length they worked fine.
JDNC, i thought of doing that, too, but then decided to sell them rather than cannibalize them
plus, the components i use for building brent's gophers work extremely well and are cheap enuf.
I checked to see if I could use a 30/06 FL die tomclose down the mouth but the case wont quite go in. I also tried a Dillon 45acp taper crimp die. It will just begin to enter the die but I haven’t tried it yet. I might have some other die to try and I’m still looking. Haven’t given up yet.
rfd,
In ref to the bore gophers, are you wetting just the front felt or both?
all gophers go for a swim in plain tap water, and after a shot is taken one is plucked out, shaken (but not stirred), pushed past the chamber, then a dry arsenal patch to follow, pushed out the muzzle into a pan of plain tap water.
BP | Bronze Point | IMR | Improved Military Rifle | PTD | Pointed |
BR | Bench Rest | M | Magnum | RN | Round Nose |
BT | Boat Tail | PL | Power-Lokt | SP | Soft Point |
C | Compressed Charge | PR | Primer | SPCL | Soft Point "Core-Lokt" |
HP | Hollow Point | PSPCL | Pointed Soft Point "Core Lokt" | C.O.L. | Cartridge Overall Length |
PSP | Pointed Soft Point | Spz | Spitzer Point | SBT | Spitzer Boat Tail |
LRN | Lead Round Nose | LWC | Lead Wad Cutter | LSWC | Lead Semi Wad Cutter |
GC | Gas Check |