Ok, first off, you dont need the hardest bullet in the world if you powdercoat. This Mihec 200gr 358 dia was cast with range scrap tested at 12br, using the hollowpoint pin, gaschecked, powdercoated, and waterdropped from the mold and after coating. I used 59gr of 4895, seated to the end of the front lube groove, this yeilds 2750fps in my 24" barrel(I plan to cut to 18") and gives me a 2" group at 95 yards. This is the first load I tried in this cartridge, and Im completely satisfied, dont really plan on changing anything. Pig was taken at dusk, trotting across the field at 82 paces, my lead hold was the snout, it was an off hand shot. Permanent cavity right behind the entrance wound, and exit wound easily would have held a red bull can. No pieces recovered, blood loss was tremendous, perhaps 2 liters, pig dropped immediately, final agonal respiration was as I approached. This is a great bullet, but Im still probably going to mix in some wheel weights, perhaps 50/50.