Im looking at getting a .38 wad cutter bullet mould . The Lee 6 cavity moulds I have are great . Im wondering how the Star lube sizer does with this Lee 358-148 wad cutter bullet as it has 3 grease grooves. All my bullet moulds have a single grease groove, my Star .358 sizing die has a lot of holes it was a standard die and I only have one row of 3 holes open . I have lubed multi grease grove 8mm bullets on my Lyman lube sizer but not on the Star .
I like The SAECO #358 148 double end wad cutter 4 cavity mould also it has a single large grease groove which I think will lube great but its pricy I have some Proofmark cast bullets that look like them but with a smaller center lube groove
How many holes in rows on a Star die can be open vertically and get good results