So I got my Lee 4-20 pot setup the way I wanted. Tried it with a couple of molds and now I decided to try my H&G #68 with it. I wasn't getting the fillout I hope I would and was getting alot of rejects. Mold is 4 cavity, PID set to 750 degrees. NOE mold guide setup installed. Mold up to temp. Not much in the way of wrinkly boolits, but more of the first band not filling out. I even got the mold so hot, the pour wouldn't solidify. I noticed on my NOE and Lee molds the sprue plate has individual sprue holes while the H&G has the trough. Never had a problem ladle pouring into it. Just seems more difficult with the H&G sprue plate. Anyone have any tips?