Trying to load some 45 ACP wadcutters and am trying to size/lube them in an RCBS Lube-A-Matic. Its the old one with the two ended ratchet wrench. Anyway, my die is stamped .452 on the top rim. It has two rows of lube holes. I have the rod up as far as it will go and each time I pull on the ratchet, it loads lube up all over the top half of the boolit and very little in the groove. I get a bit on the base of the boolit too. If I set the rod so the boo lit goes deeper, its a mess with lube ll over the top of the boo lit like a blanket wrap. Could I have the wrong die for 45 ACR wadcutters?