So i picked up a Model 33 Husqvarna in 9.3x57r. The 9.3 rimmed family comes in a variety of lengths from 57 to 82, I can get both 9.3x72r brass and dies. Buffalo Arms has a C&H set for just north of 100 bucks. Just so there is no confusion these are both straight walled cartridges, and should not be confused with the 9.3x74r that has a necked down case. Here is the question. The 72r cartridge is 15mm longer than the 57r that translates to 0.590. Could i find a machinist with a lathe and just trim off the difference and re-chamfer the ID. Anybody have any experience or thought on this idea.
Thanks
Michael