Anybody ever wear out a Ram Link, Ram Link Pin, and Shaft Assembly on a Star Lubesizer? Is this common? Just cost me $50 odd dollars including shipping for parts. I throw a couple lubed boolits back through every ten or twenty or so and I am only sizing from .360 to .358. The threads are not hitting the die and there is was no bind until these parts wore. The upper hole in the the Ram Link was wallowed out to an oval about 3 times the standard diameter of the hole, the pin was worn almost all the way through in the middle due to the ovaling of the Ram Link, and Shaft arm that actuates the lube plunger had worn significantly. I am complaining a little but this thing has 40k-50k boolits through it, so I don't think its all that bad. Its been an invaluable piece of equipment and I did buy it used. What are your experiences folks?