Because when I asked what settings needed to be changed in cura other than infill, this is what I was told.
Not knowing what I am doing didn’t want to change things that were not suggested by the designer at first.Layer Height 0.15 or 0.10
Infill Density 80% or 100%
Wall Count: 4 or 6
Generate support: off
build plate adhesion type: brim
brim width: 6 mm or 8 mm
cooling: enabled
retraction: enabled
You have to assume that you are talking to a fellow that knows about as much about 3D printing as he can glean from the cardboard box, because that is who you are talking to.
Trying another one with
v2 base plate mrbullet feeder
layer height .15
Shell thickness .8 for Wall and bottom/top
Infill 80%
Printing temp 200
Plate temp 70
Diameter 1.75
Flow 100
Speed print 50
Travel 120
Cooling enabled
No support
Adhesion brim, 12mm
Using cura
Shaxon PLA
Glass bed
Aqua net extra super hold unscented
.0035” gap