Does anyone have experience with using Lee Alox lube on boolits that were found to be defective AFTER they were lubed, and were then returned to the pot for re-melting? I'm wondering if the Alox will contaminate the pot or molds, in any way?
I have a lot of lubed boolits from several molds that are not good enough to load and shoot, and I've been hesitant to return them to the pot, for fear of ruining the alloy mix and/or molds with Alox. To those of you who are laughing at my not spotting the defects before tumble lubing them with Alox, all I can say is wait till you're 80 years old and have Macular Degeneration!
Thanks,
Fred (Honcho)