I finally got the wireing hooked up to my therms. on my (new to me) Ballisti MK-2,,( thank's to Hatch,and this forum) brought the heat up slooowly . There were (are) 4 set's of mould's already in the unit,, they are Hensley & Gibbs-Ballistiast's,heat @ 685 deg. ,flipped the drive sw.,pulled the lever dn. by hand, watched the 2 tips fill ,,had mtr. speed set slow,,poured perfect (as far as I know). This unit has been setting idle for almost 4 yrs. ( It did not leak at the tip's -nozzles ). I have no use for the moulds in it,,they are for muzzle loader's ,, I shoot 40/60 winchester .406 dia. 200-210 gn. & 245gn.,rnfp . I need a little help in getting some mould's to fit my unit new OR used . PM's or E-mail ok.
Later,,,,Hootmix.