So I have quite a few old military rifles that I haven't shot for a while due to the fact that ammo is so hard to find for some of them. Now that I've been casting for a little while, I feel like I could get off my butt and do something about that.
Ideally I'd like one mold (or maybe two) that I could use for all these old rifles. If I could get away with sizing the same bullet in a variety of sizes to meet each caliber I feel like that'd make my life a lot easier.
So here's a partial list of some of the rifles I'd like to cast for, and if I could get any recommendations for them I'd appreciate it. I'm not planning on doing anything impressive with these rifles, not competitions or anything, just punching holes in paper every once in a while.
M1 Garand
M1 Carbine
Type 99 Arisaka
k98 Mauser
k31 Swiss
Lee-Enfield
thanks in advance!